Page 1252 - MiSUMi 2025

Economy series Product Overview Product Overview Economy series
Circular Posts / Hex Posts Circular Posts / Hex Posts

QSalt Spray Test Report
Economy series New MISUMI Economy series MISUMI Standard products
Specs
Circular Posts / Hex Posts Material: Material:
SS400
General Structural Steel or SUM
Material
Surface Treatment: Surface Treatment:
Electroless Nickel Plating
Nickel Electroplating or Electroless Test Result:
Easy installation Nickel Plating No Obvious Rust
Test Result: Before Test After Test Before Test After Test
Excellent anti-rust performance No Obvious Rust
Generic products on the market 1* Generic products on the market 2*
Diverse Specifications Material: Material:
S45C SUM23
Surface Treatment: Surface Treatment:
Electroless Nickel Plating Electroplated Nickel Plating
Test Result: Test Result:
Large Area of Corrosion Completely Rusted
Before Test After Test Before Test After Test
· Test Method: Corrosion test according to standard ASTM
16 QLineup of Products Hex Posts Circular Posts · Test Conditions: 1 Salt water spray test (5%NaCL35°C) Conclusion of corrosion resistance comparison:
B117 test method
Posts / Strut Clamps / Angle Plates Both Ends Tapped * Generic products on the market are similar products randomly purchased by MISUMI from online or offline markets
MISUMI Economy series is
2 Volume of salt solution 1.0~2.0ml/hr
equivalent to MISUMI Standard products
3 Salt solution PH value 6.5~7.2
* The test data are obtained through testing by MISUMI, which are for reference only

One End Threaded, One End Tapped G G
Posts G G QExample of Use

Both Ends Threaded
P.16-005 N G
Strut Clamps / Brackets One End Tapped N G

P.16-023 One End Threaded
Angle Plates Stepped, Both Ends Tapped G G

P.16-031 G G

QProduct use and relief groove reference value

· Feature: The Hex Post offers more positions for wrench · Post Dimensions of male thread relief groove
use compared to the Circular Post. A wrench can still (reference value)
be used even near to the workpiece, and it can be M
repositioned every 60°. When using the Circular Post,
make sure there is enough space to turn the wrench.
MC
g
M MC g
3 2.3 1
4 3 1.2
60° 5 3.9 1.5
180° 6 4.3 2
When using a wrench When using a wrench 8 6.2 2.5
16-005 on the hex post on the circular post