Page 1491 - MiSUMi 2025

Product Overview Economy series
Slide Rails

Economy series

Slide Rails MISUMI LOGO Engraving

Quality Assurance
Smooth sliding and durable
New product with tap for
easy installation
21 21

Handles / Hinges / Door Parts / Slide Rails / LED / Signal Towers QDurability Test QSalt Spray Test Slide Rails / LED / Signal Towers Handles / Hinges / Door Parts /

· MISUMI Economy series Slide Rails are stamped
with high-quality self-made mold, and the
Slide Rails (steel) ensures 24
assembly accuracy of finished products is · MISUMI Economy series
Handles guaranteed. After 50,000 cycles of reciprocating hours salt spray test without Handles
rusting and excellent rust
movement with load, it can still be used normally in
prevention performance.
smooth sliding without deformation in appearance.
P.21-008 Test Conditions: Install the sample correctly on the durability tester, load 24.5KG Test time (H) Generic products on the market * MISUMI Economy series P.21-008
in the drawer, make continuous pushing and pulling movement with a speed of
12 cycles/minute, observe the change of the sample and record the state of the
Hinges / Magnetic Catches product when the corresponding number of cycles is reached. 24 Black spots appear in one place 2% black spots at the inner rail Catches Hinges / Magnetic
Normal
Number of cycles Sliding resistance
Sag when fully extended
10% black spots at the inner rail
48
1mm
0.8KG
10000
0.7KG
30000
1mm
P.21-017 20000* 0.8KG 1mm 72 Large area of rust at the outer rail 3% black spots at the outer rail P.21-017
40000 0.7KG 1.2mm 96 Large area of red rust inside the Black spots inside the slide
50000 0.7KG 1.2mm slide rail with steel ball rusted rail with steel ball rusted
Locks * With opening and closing every ten minutes, 20000 cycles is about equal to the * Generic products on the market are similar products randomly purchased Locks
number of uses in a year.
by MISUMI from the market
* The test data are obtained through testing by MISUMI, which are for reference * The test data are obtained through testing by MISUMI, which are for
only reference only
P.21-032 P.21-032
QInstallation Precautions
Knobs Process Hole Sectional Sectional View Knobs
View of with Tap
P.21-042 Outer Rail Mounting Hole Normal Type Accessories P.21-042
Accessories Required:
Slide Rails Slide Rails and the mounting hole, please move the Screw + Nut Slide Rails
Required:
Screw
When installing the interference part between the
process hole to a position above the mounting hole
before installing the screws.
P.21-050 QPrecautions for use P.21-050
LED Lights / Multi-layer Signal Lights · Example of installation direction · Slide Rails when ball creep occurs Slide Rail Multi-layer Signal Lights LED Lights /
Offset due
Outer
to ball creep
Inner Slide Rail
Retainer
When normal
P.21-060 When creeping P.21-060
Other New Products Vertical and parallel installation Slide Rails are not mounted vertically Because of the offset, the retainer has reached the left end of the outer slide Products Other New
rail, but it is not in the full stroke state.
In order to eliminate the ball creep phenomenon, please apply force to make
P.21-071 the inner Slide Rails slide to the full stroke state. P.21-071
Action
Direction 〃 Force Action Force Force
Apply force to the far center of gravity Direction Direction Direction Direction
Slide Rails are not on the same horizontal line when it is installed horizontally
* It is recommended not to use it when torque loads are applied 〃
21-049 Before pulling out After pulling out 21-050