Page 1121 - MiSUMi 2025

Economy series Product Overview Product Overview Economy series
Motorized Goniometer Stages Motorized Goniometer Stages

Locating Pins When the upper plate is slid to CW or CCW direction, 2 Pins Locating
Installation method
counterbored holes are visible (4 holes in total). When a sine
motion stage is driven through the controller, the limit sensor
P.12-009 works, but there is no guarantee for the detection of mounting P.12-009
holes. Be sure to manually expose the mounting holes and
Bushings For Locating Pins secure with the supplied bolts. Locating Pins Bushings For

About objects mounted on the top / bottom of the stage
P.12-053 If an object with an uneven surface is mounted or the stage is P.12-053
mounted on an uneven surface, the flatness and accuracy may
be affected.
Adjusting Bolts / Adjusting Stopper Screws / Clamping Screws Please pay attention to the above instructions. Clamping Screws Adjusting Stopper Screws / Adjusting Bolts /
[Reference standard of flatness: 10μm or less]
About installation posture of positioning stage
P.12-061 The horizontal installation of the stage is a prerequisite for the P.12-061
Polyurethane Pushers performance parameters of each product. Pushers Polyurethane
Be careful when using a product that is mounted upside down,
to the side (vertically or horizontally), or in any posture other
The load capacity and accuracy may vary greatly with the
P.12-069 than on a level surface. P.12-069
installation posture.
Micrometer Heads For Product Features by Posture information, please refer to Heads Micrometer
below table:

P.12-073 ▼Table of Product Features by Posture P.12-073
Part Number Movable guide (feeding method) Upside-down use Side (horizontal) use Side (vertical) use
Positioning Stages O Usable, with restrictions on load and torque. G G G Upside-down mounting Side (vertical) mounting Stages Positioning
E-GMPG
Cross roller
(ball screw)
E-GMPWG
P.12-075 QAbout Swing Accuracy and Rotation Center Height P.12-075
Other New Products MISUMI cross roller type goniometer stages have a very small swing around the center of rotation and high Products Other New
accuracy.

P.12-115 Swing accuracy of rotation center P.12-115
12 Place a steel ball at the height of the center of rotation (the actual center of rotation, not the theoretical 12
point in the design), and use the amount of swing (X.Y.Z) of the ball during the full stroke movement as the
swing accuracy of the rotation center.
Locating Pins & Bushings / Position Adjustment Parts / Positioning Stages The height of rotation center is the distance between the top of the stage and the center of the steel ball of the guide. Adjustment Parts / Positioning Stages Locating Pins & Bushings / Position
Rotation center height (interval between workpieces)

Usage difference between Economy series and Standard products

MISUMI Standard products MISUMI Economy series
Suitable for applications Suitable for applications not
requiring high precision such requiring high precision such
as precise adjustment as simple adjustment

Equipment name: Workpiece Assembly Posture Fine-Adjustment Device Equipment name: Motor Installation Error Simulation Testing Machine
12-109 12-110